Most air conditioners undergo three cooling cycles an hour, each lasting roughly ten minutes, on a moderately hot day. This means that during a single hour, the compressor will run for 10 minutes, shut off for 10, and then repeat the cycle twice. Short-cycling occurs when the cooling cycle is much shorter than the typical 10 minutes, resulting in more frequent on and off cycles for the compressor.
In addition to wearing out the compressor, this constant stopping and starting deprives your home of its cooling comfort and will likely require air conditioning services in Allentown, PA.
Here Are Four Likely Culprits For Short Cycling:
Unclean Air Filter
You will restrict your air conditioner’s airflow if the air filter is dirty. The system overheats as a result of this and shuts down. To stop this from happening, you must routinely clean or replace your air filter.
Electrical and Wiring Issues
Your air conditioner or heat pump may briefly lose power due to several electrical problems, including loose or corroded electrical connections. It’s best to call us right away if you have any electrical issues because you’ll need expert assistance for AC repair in Allentown, PA.
An oversized AC will probably overshoot the desired temperature, cycle off, and turn back on as soon as the house starts warming up. The only option is to swap out your current air conditioner for one that is the right size.
Frozen Evaporator Coils
When it’s too cold outside and an air conditioner is running, it can occasionally freeze, usually at night. Restart your system after it has been thoroughly defrosted. If the coils freeze once more, contact a professional for AC repair in Allentown, PA.
Ways to Stop Your Air Conditioner From Cycling Too Quickly:
Check Your Air Filter:
A clogged air filter can bring on numerous air conditioning problems. If your air filter is caked with dust and debris, it’s a good idea to check and replace it.
Check The Refrigerant Levels:
Having a qualified expert check the levels and, if necessary, adding more refrigerant is a good idea.
Replace The Low-Pressure Control Switch:
If short-cycling problems persist after the checks, you should have your HVAC technician replace the low-pressure control switch with a new one.
Examine The Compressor:
It’s a good idea to have your HVAC professional check and, if necessary, replace the compressor, as a failing compressor may also display short-cycling symptoms.
Check The Location of Your Thermostat:
It’s best to install it on a wall inside your home, in the middle of the room. To prevent your thermostat from being confused by the influx of cool air and giving inaccurate readings, make sure it isn’t too close to the return air register.
You can avoid most short-cycling issues with routine maintenance. Short cycling in your HVAC system is typically an indication of a more severe problem. Complete Home Specialist, LLC will be able to restart it. Contact us immediately for more details about air conditioning services in Allentown, PA.